this is a interesting site to have a look at for motors and gear reducion stuff - found it while trolling around for "mabuchi" stuff....


Mabuchi RF-500TB-12560 Motor

http://www.hobbyengineering.com/H3388.html


Motors Section

http://www.hobbyengineering.com/SectionM.html



Miniature Gear Motor: Right Angle Shaft

http://www.hobbyengineering.com/H1212.html

just f.y.i.

This message has been edited. Last edited by: phatchantz,

that last one sounds a little too slow.

Hmmm, that last one sounds very intruiging to me! If you were to find a way to run the NB axle right off the output shafts, you would have the same gear reduction as Tex. I'm a bit concerned about the clutch thing though and it wimping out right when the going gets good. What about the big brother they mention?

I just kinda tossed this site up for some place to poke around and see what was what - I actually didn't realize that some of this stuff even existed -

I'm still searching for more motors, and gears etc