hi guys i spoke about this a while back i have not had time to develope it may be one of you guys could try . here we have hobby grade wheel hexes my idea is simple .the pins you see go through the axel a small hole needs to be drilld in the flat end of the axel to take this pin the hexx just slides over the axel and locates on the pin this is how all hobby grade wheels are mounte the hexx come in different sizes from 12mm right up to 17mm and above you just need to fitt the hobby hexx to our newbrights and you can mount hobby wheels. sorry i have not had the time to experiment with this ...
One day, someone showed me a glass of water that was half full. And he said, "Is it half full or half empty?" So I drank the water. No more problem. ~Alexander Jodorowsky.....
any input is more than welcome .i understand the 1/10 models the wheels screw on iam unsure .
One day, someone showed me a glass of water that was half full. And he said, "Is it half full or half empty?" So I drank the water. No more problem. ~Alexander Jodorowsky.....
i understand wayne.s i also do like the wheels on the 1/10 .much better than the 1/6 .the wheels on the 1/6 use a nutt to fix wheel to axel much like hobby grade but the hex is different it sits inside the front of the wheel and not the back like hobby wheels do .this could be very easy to correct .also for the 1/10 .i have just not had the time to do this. thanks. may be you could look into it if you have time .thanks
One day, someone showed me a glass of water that was half full. And he said, "Is it half full or half empty?" So I drank the water. No more problem. ~Alexander Jodorowsky.....
