|
|
|
|
Go
|
New
|
Find
|
Notify
|
Tools
|
Reply
|
|
Newbie |
I have a project CJ7 that someone else started and I finished. I'm not a real seasoned mechanic, so I pose this question. I have a '93 4.0 mated to a '94 AW4; should I be able to see the flywheel? I've been concerned about this for a while and am now prepared to fix, if necessary. It seems like mud, rocks, etc. could just get right in my tranny.
'78 CJ7 |
||
|
Extreme Rockcrawler |
No, sounds like you are missing a dust shield or two. Should have been a 2 piece aluminum dust shield to cover up that part.
Jason  1997 TJ 4.0L AW4 D44/Super 8.8 35x12.5 KM2, Onboard Air Gen II AiRock/Longarms PRR Inc, Because rocks can't drive |
|||
|
|
Rock Monger Extreme Rockcrawler  |
 ------------------------------  93 YJ, 35" MT/Rs, 5.5" lift, HP D44 front, D44 rear, 4:1 tera low, locked, geared, dented and scarred.06 Ranger 4x4. |
|||
|
|
Newbie |
Yeah, alosix, you're right. I'm missing my lower dust shield. Thanks
'78 CJ7 |
|||
|
|
Extreme Rockcrawler |
I'm not sure if the TF999 dust shields end up being the same, but I should have an extra set at some point. Might be able to send them over to you.
Jason 1997 TJ 4.0L AW4 D44/Super 8.8 35x12.5 KM2, Onboard Air Gen II AiRock/Longarms PRR Inc, Because rocks can't drive |
|||
|
|
Newbie |
Thanks for the offer alosix. I've already taken care of it.
'78 CJ7 |
|||
|
| Previous Topic | Next Topic | powered by eve community |
 | Please Wait. Your request is being processed... |
|
|||
| Site | ROCKCRAWLER.com RCBoards | ||
| Servlet | eve2da015 | ||
| Version | 1.2.22 build 9062 | ||
| Module | Forums 4.0.3 | ||
| Stylesheet | "Jeeps General" | ||
| Wordlet Set | "Default Wordlet Set" | ||
|
