How much would it cost to ship a RE1600 tracbar to 38127?
Also the alignment shop recommended that i try to find a angled end tie rod end for the draglink to pitman arm since it was cockeyed <i hope that isnt a dirty word>. do those exist?

ship from where to 38127???

i can ship that fed ex for about 10$


if your lifted and your draglink is very angled some times a little bend helps out the ball joint. but not too much!!!!


i just make my own.

1 3/4" .250 dom should be fine. carefull bending that, it thick.


larrygo

quote:

---

Originally posted by XJ Nate:
How much would it cost to ship a RE1600 tracbar to 38127?
Also the alignment shop recommended that i try to find a angled end tie rod end for the draglink to pitman arm since it was cockeyed <i hope that isnt a dirty word>. do those exist?

---

Sounds like that aligment shop is giving you the run around. at 4.5" of lift, the angle on your tie-rod is just fine. When your reaching 8"...then you need to start looking at cross over steering...not some bent up tie-rod to help angles

Uncle: you have a RE trackbar?
Renegade: I believe it is still stock draglink and tie rod but I am just going to get a OEM one from my cousin try to keep the price down til i am ready to get a new assembly.
Plus i want new shocks.