ROCKCRAWLER.com    ROCKCRAWLER.com RCBoards    ROCKCRAWLER.com RCBoards  Hop To Forum Categories  Shop Talk    Moab Powertrain

Moderators: ThePagan, TXJEEPER, Xtremjeepn
Go
New
Find
Notify
Tools
Reply
  
-star Rating Rate It!  Login/Join 
Pebble Hopper
Rockcrawler
Posted
I trashed my end yoke and tore apart a U-joint on my TW rear shaft while "experimenting" with Double Whammy last week. Saw this shop, it had a Tom Woods banner, so I swung in looking for replacement parts, not sure what I'd find. Turns out this shop is owned by Tom Woods' son, Shawn, so I guess I came to the right place! He had me set up in no time, and even volunteered to loan me the use of an impact wrench and creeper. He is a young feller who admitted that he "wouldn't know how to take apart a diff" and hasn't started wheeling yet, but this man KNOWS driveshafts! 5 stars.


__________________________
 
Posts: 621 | Registered: August 02, 2001Reply With QuoteEdit or Delete MessageReport This Post
Newbie
Picture of alwaysbroken
Posted Hide Post
I was there for EJS snaped my new CV ( that i bought somewhere else) that i had built before the run and Tom Woods hooked me up with a whole new drive shaft in a couple of hours and it was cheaper than the first i had bought..
Tom Woods was there helping out for that week.


1977 CJ-7 Dana 44 front 60 rear, Fuel injected 350, NV4500,Dana 300, 4 link rear axle moved back 4", 37" Boggers.(sold)
1989 Cherokee, prorock 60 front, tera 60 rear, 37" mtrs
 
Posts: 39 | Location: Rancho Cucamonga | Registered: February 09, 2004Reply With QuoteEdit or Delete MessageReport This Post
 Previous Topic | Next Topic powered by eve community  
 

ROCKCRAWLER.com    ROCKCRAWLER.com RCBoards    ROCKCRAWLER.com RCBoards  Hop To Forum Categories  Shop Talk    Moab Powertrain

© Copyright 2007 Rockcrawler 4x4 and Off-Road Magazine