A few weeks back I got hooked up with "Flapdig" and he was going to make me some 70:1 Gears. So I mailed them out to him and they never made. I am Guessing the mail lost them and there is nothing they will do.It's been 4weeks now and still no sighn. My crawler is out of commition untill I find some new gears, SO if you happen to have some or know where I can get some PLEASE let me know!..Thanks Guy's!

Which gears do you need?

what scale what model, what voltage? they all run different ratios

AirborneJordan ..These should certainly seek gear 1/10 rubicon / 1/10 toyota fj cruiser ..

This message has been edited. Last edited by: loulou,

Sorry guys, sorry I should have gave more info..They will be for the 1/10Th FJ.. and the 2 gears I need are the one that touch the pinion gear on the motor.

O-and thank for taking a look for me !

You can always go the route of putting a 60 (the stock is a 42 tooth)tooth Spur gear on the axle and change to an 8 tooth pinion(10 stock). Not too sure if the ratio will be as low as Flapdings but it will be a lot lower than stock.

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXJHN5&P=OW
http://www3.towerhobbies.com/cgi-bin/wti0001p?Q=&I=LXBGE4

Well..In the end i will end up with flapding's 70:1's But I need the stock ones so he can make them for me. I have all ready payed him to do so....If any one has them laying around You can just send them to MR.Flapding, He all ready knows "The deal"

I got a hold of a pair ! Thanks to you guys who checked into it for me !