I had mostly everything, now it is dwindling. Another project took them up

I do however still have an uncut 1:6 scale chassis if someone needs one

This message has been edited. Last edited by: j33p3r,

hey, do you have any complete stock chasis with stock electronics?

for jeep or landrover? I have stock chassis with electronics for the landrover.
I'm a bit suspect of the electronics inthe jeep. It was cutting out a bit, so not sure if it was a connection or what. So I would say no on the jeep and yes on the landrover. yes they have different chassis

Any 1/10 scales?

no , I have no newbright 1:10's I do have some other brand stuff around in 1:10

Do you have a steering motor with the wire to plug into the circuit board?

yes I do have this part if you mean the steering servo.

I'll take a picture

Hey I am looking for a rolling chassis for a Yukon Denali 1:6 Scale by New Bright

I have a chassis with all but the axles and wheels

Have about 2 yr old Walmart LARGE Hummer. Prob a 1:6 scale. Need new nylon frt spindle(s)

Lyle

quote:

Originally posted by j33p3r:
I have most everything in 1:6 available at the moment, I have 3 in various stages but am only building 2 newbrights

just reply or pm me, boards controllers , stock chassis (uncut)

do you have a picture?

how much would you say is acceptable for a chassis

The 1:6 jeep chassis? I have a stock uncut one you can have for 10 dollars plus ship

I need the driver's side spindle for the 1/6 scale Dodge Hemi (6687) truck. Do you happen to have this??

left is good spindle right is broken off tie rod flange

lyletomkins@comcast.net

quote:

Originally posted by j33p3r:
do you have a picture?

I'll check tonight to see if mines the same as these

Any word on these parts, j33p3r??

No good - different appearance. Sorry for the delay.